J. M. Corum, R. L. Battiste, M. B. Ruggles-wrenn, and «. Low, Low-energy impact effects on candidate automotive structural composites, energy impact effects on candidate automotive structural composites, pp.755-769, 2003.
DOI : 10.1016/S0266-3538(02)00265-8

L. S. Sutherland, C. Guedes, and . Soares, Effects of laminate thickness and reinforcement type on the impact behaviour of E-glass/polyester laminates, Composites Science and Technology, vol.59, issue.15, pp.2243-2260, 1999.
DOI : 10.1016/S0266-3538(99)00080-9

N. J. Lee and J. Jang, The effect of fibre content on the mechanical properties of glass fibre mat/polypropylene composites, Composites Part A: Applied Science and Manufacturing, vol.30, issue.6, pp.815-822, 1999.
DOI : 10.1016/S1359-835X(98)00185-7

J. Rout, M. Misra, S. S. Tripathy, S. K. Nayak, and A. K. , The influence of fibre treatment on the performance of coir-polyester composites, Composites Science and Technology, vol.61, issue.9, pp.1303-1310, 2001.
DOI : 10.1016/S0266-3538(01)00021-5

J. L. Thomson, Micromechanical parameters from macromechanical measurements on glass-reinforced polybutyleneterepthalate, Composites Part A: Applied Science and Manufacturing, vol.33, issue.3, pp.331-339, 2002.
DOI : 10.1016/S1359-835X(01)00129-4

N. J. Lee and J. Jang, The effect of fibre-content gradient on the mechanical properties of glass-fibre-mat/polypropylene composites, Composites Science and Technology, vol.60, issue.2, pp.209-217, 2000.
DOI : 10.1016/S0266-3538(99)00122-0

J. Jang and S. Han, Mechanical properties of glass-fibre mat/PMMA functionally gradient composite, Composites Part A: Applied Science and Manufacturing, vol.30, issue.9, pp.1045-1053, 1999.
DOI : 10.1016/S1359-835X(99)00021-4

W. J. Cantwell and S. J. Youd, Rate effects in the fracture of glass fibre chopped strand mat composites, Composites Part B: Engineering, vol.28, issue.5-6, pp.635-640, 1997.
DOI : 10.1016/S1359-8368(96)00081-9

J. L. Thomason, The influence of fiber length and concentration on the properties of glass fiber reinforced polypropylene. 6. The properties of injection molded long fiber PP at high fiber content, J. Composites: Part A, vol.xx, pp.1-9, 2004.