Measurement of residual stresses and toughness in Ti-6Al-4V material produced by Laser Beam Manufacturing
Résumé
This study deals with the measurement of residual stress by the hole drilling method in Ti-6Al-4V samples obtained by Laser Beam Manufacturing after stress relieving. Indeed, it was of high interest to check the efficiency of such a thermal post-treatment. The influence of the orientation of both the sample and the notch is evaluated from a toughness point of view, and the obtained values are compared to that of similar parts submitted to Hot Isostatic Pressing after stress relief treatment. A more isotropic behaviour were detected on the HIPed samples (with respect to that of the stress relieved ones) with a higher average value. This development is discussed from both residual stress and microstructural points of view.